8Alarm
DX100 8.3 Alarm Message List
8-540
9 The position conversion could not
be done in the designated
coordinate system at the offline
position data conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
10 Incorrect incremental value of
angle for offline position data
conversion
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
11 The position data could not
correctly be added by the
incremental value of angle at the
offline position data conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
12 The reverse shift value for 3D
shifting could not correctly be
calculated at the offline position
data conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
13 The reverse shift value for 3D
shifting could not correctly be
added at the offline position data
conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
14 The reverse shift value could not
correctly be calculated at the
offline position data conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
15 The reverse shift value could not
correctly be calculated at the
offline position data conversion.
Software operation
error occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
