YASKAWA DX100 - Page 691

8Alarm
DX100 8.3 Alarm Message List
8-576
4945 MOTION
COMMAND DATA
ERROR (SV)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4946 PG POWER ON
INCOMPLETE (SV)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4947 SERVO ON
MULTIPLE
REQUEST (SV)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4948 ENCODER ALARM
(SERVO)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4949 GUN BEND MULTI
CORRECT ERR
(SV)
Setting error Check the settings for jobs.
4950 MOTOR GUN
POS. DIFF. OVER
(SV)
Sub Code: Signifies the axis in
which the alarm occurred
Setting error Check the settings for jobs.
4951 WRONG MOTOR
GUN CHANGE
AXIS (SV)
Sub Code: Signifies the axis in
which the alarm occurred
Setting error Check the settings for jobs.
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy