YASKAWA DX100 - Page 692

8Alarm
DX100 8.3 Alarm Message List
8-577
4952 WRONG MOTOR
GUN FILE NO.
(SERVO)
Sub Code: Signifies the axis in
which the alarm occurred
Setting error Check the settings for jobs.
4953 ENCODER
COUNTER DIFF.
ERR(SV)
Sub Code: Signifies the axis in
which the alarm occurred
Setting error Check the settings for jobs.
4954 REALTIME
STATUS S/R
ERROR (SV)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4955 AVERAGING DATA
ERROR (SERVO)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4956 AVERAGING SUM
ERROR (SERVO)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
4957 AVERAGING
STATUS ERR
(SERVO)
Software operation
error occurred
(1)Reset the alarm.(In case of major alarm, turn the power OFF then back
ON.)
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy