8.6 Anti-Resonance Control Adjustment
8.6.3 Operating Procedure
8-26
3.
If you do not know the vibration frequency, click the Auto Detect Button. If you know the
vibration frequency, click the Manual Set Button.
4.
Click the Start adjustment Button.
5.
Use the and Buttons in the Adjustment Area to change the settings.
Click the Reset Button during tuning to restore the setting to its original value. The tuning level will
return to the value from before when custom tuning was started.
6.
When the adjustment has been completed, click the Finish Button.
The values that were changed will be saved in the SERVOPACK and you will return to the Tuning Dia-
log Box.
This concludes the procedure.
To Automatically Detect the Vibration
Frequency
The frequency will be set.
To Manually Set the Vibration Frequency
To Automatically Detect the Vibration
Frequency
Change the setting of the damping gain.
To Manually Set the Vibration Frequency
Change the settings of the frequency and
damping gain.
To Next Page
Loading...
Need help?
General
