YASKAWA E-S Series - Servomotor Selection

5.2 Servomotor Selection
5-9
5
Setup
5.2 Servomotor Selection
Use Pn08A (Motor Selection Switch) to set the motor code of the Servomotor to use. The
default setting is for a 30-W motor.

Monitor Codes
7001h: 30 W (Servomotor model: SGMSL-A3)
7002h: 50 W (Servomotor model: SGMSL-A5)
DANGER
 Set the motor code correctly.
If the motor code that you set does not agree with the connected motor, unexpected opera-
tion may occur or the Servomotor may be burnt.
Pn08A
Motor Selection Switch
Setting Range Setting Unit Default Setting When Enabled Classification
7000h to FFFFh – 7001h After restart Setup