H: Upgrade Kit Instructions
MIFARE & Contact
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 317
Step 4. Attach the SCM ground wire to one of the unused tabs on the Ground Plate
(circled below).
Reassembly
Replacement is performed by reversing the removal steps.:
a. Remove the Front Bezel (page 315)
b. Remove the Bottom Cover (page 314)
c. Remove the Right Side Cover (page 313)
d. Remove the Left Side Cover (page 312)
NOTE • Torque values are specified in the corresponding removal step.
Important • Refer to Appendix I for configuration procedure.
To Next Page
Loading...
