ABB RELION Series - Settings; Signals

3.19.2.3 Signals
Table 199: SCHLCCH1 output signals
Parameter
Values (Range) Unit Step Default Description
CH1LIV True
False
Status of Ethernet channel X1/LAN.
Value is "True" if the port is receiving
Ethernet frames. Valid only when
Redundant mode is set to "None" or port
is not one of the redundant ports (LAN A
or LAN B).
LNK1LIV
Up
Down
Link status of Ethernet port X1/LAN.
Table 200: SCHLCCH2 output signals
Parameter Values (Range) Unit Step Default Description
CH2LIV True
False
Status of Ethernet channel X2/LAN.
Value is "True" if the port is receiving
Ethernet frames. Valid only when
Redundant mode is set to "None" or port
is not one of the redundant ports (LAN A
or LAN B).
LNK2LIV
Up
Down
Link status of Ethernet port X2/LAN.
Table 201: SCHLCCH3 output signals
Parameter
Values (Range) Unit Step Default Description
CH3LIV True
False
Status of Ethernet channel X3/LAN.
Value is "True" if the port is receiving
Ethernet frames. Valid only when
Redundant mode is set to "None" or port
is not one of the redundant ports (LAN A
or LAN B).
LNK3LIV
Up
Down
Link status of Ethernet port X3/LAN.
3.19.2.4 Settings
Table 202: Port mode settings
Parameter
Values (Range) Unit Step Default Description
Port 1 Mode Off
On
On Mode selection for rear port(s). If port is
not used, it can be set to “Off”.
Port 2 Mode Off
On
On Mode selection for rear port(s). If port is
not used, it can be set to “Off”. Port
cannot be set to “Off” when Redundant
mode
is “HSR” or “PRP” and port is one
of the redundant ports (LAN A or LAN B).
Port 3 Mode
Off
On
On Mode selection for rear port(s). If port is
not used, it can be set to “Off”. Port
cannot be set to “Off” when Redundant
mode
is “HSR” or “PRP” and port is one
of the redundant ports (LAN A or LAN B).
Section 3 1MRS758755 A
Basic functions
198 REC615 and RER615
Technical Manual