Troubleshooting
Page 114 Acterna ANT-5
3. The battery compartment is located underneath the ANT-5, just behind the front
bumper. Access is provided by two screws at the rear edge of the battery
compartment cover.
4. Remove the two screws and open the cover to reveal the battery pack. Do not
remove any other screws.
5. Carefully lift out the battery pack and disconnect the battery cable at the plastic
connector where it emerges from inside the ANT-5.
6. Plug in the replacement battery pack and place it in the battery compartment.
7. Refit the battery compartment cover.
8. The battery pack should now be charged and conditioned as described in Section
7.6.1, Battery conditioning. This procedure will establish the initial conditions for
the battery charge indicator.
7.7 Accessing test results if the unit has been powered down.
The ANT-5 will not switch itself off if a test is running. However, if the unit is
accidentally switched off, or there is no power left in the battery, results will be saved
in the internal: device of the File Manager. These will be saved as AUTO files, with
suffixes of .A5R; the time and date will also be present so that the results are easily
identified.
To Next Page
Loading...
