Appendix B – Standards Compliance
Acterna ANT-5 Page 125
10. Appendix B – Standards Compliance
10.1 Electromagnetic Compatibility
This instrument meets the CE requirements of EMC Directive 89/336/EEC and its
amendments. The standards applied are:
EN 61326 1997 ......................................Electrical equipment for measurement, control
and laboratory use – EMC requirements.
EN 55022 (CISPR 22) 1998 ................................... Radiated and conducted emissions
IEC 1000-4-2 1995...................................................Immunity to electrostatic discharge
IEC 1000-4-3 1995....................................................Immunity to electromagnetic fields
IEC 1000-4-4 1995....................................................... Immunity to fast burst transients
IEC 1000-4-5 1995........................................................................... Immunity to surges
IEC 1000-4-6 1996................................................................ Immunity to conducted RF
10.2 Safety
The instrument complies with the safety objective of:
The Council Directive dated 19
th
February 1973 on the approximation of the laws of
the Member States concerning electrical operating equipment for use within certain
voltage limits (Low Voltage Directive – 73/23/EEC), amended by the Council Directive
dated 22
nd
July 1993 (93/68/EEC).
To test the compliance of the instrument the following standard was used:
EN 61010-1 (1993/A2:1995) Safety Regulations for Electrical Measuring, Control and
Laboratory Instruments – Part 1: General Requirements.
This equipment is intended to be used in a pollution degree 2 environment and is
considered to be installation category II.
For indoor use only.
The following only applies if optical interfaces are fitted:
WARNING: Class 1 Laser Product.
10.3 R&TTE Directive
Hereby Acterna declares that this SDH Tester is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
To Next Page
Loading...
