Chapter 10 123
Command Reference
Query response
10. Command Reference
Query response
The section under the heading “Query response” describes the data format read out when
query (reading out data) is available with the command.
Each readout parameter is enclosed with { } symbols. If there are several items within { }
separated by a pipe (|), only one of them is read out.
When several parameters are read out, they are separated with a comma (,). An ellipsis (…)
between commas indicate that the data of that part is omitted. For example, {numeric
1},…, {numeric 4} indicates that 4 data items, {numeric 1}, {numeric 2}, {numeric 3},
and {numeric 4}, are read out.
<newline><^END> after the parameters is the program message terminator.
Related commands
The section under the heading “Related commands” lists other commands associated with
the current command.
Equivalent key sequence
The section under the heading “Equivalent key sequence” shows the operational procedure
of the front panel keys that has the same effect as the command.
[Key] Indicates the hardkey whose key label is Key.
[Blue] - [Key] Indicates that you press the blue shift key to activate the shift function
(2nd function printed in blue) and then press the hardkey whose key
label (printed in dark gray) is Key.
[Key] - Item Indicates a series of key operations in which you press the [Key] key,
make the item called Item on the displayed menu blink by using the
[←↓] key or other means, and then press the [Enter] key.
To Next Page
Loading...
Need help?
General
