128 Chapter 10
Command Reference
*STB?
*STB?
Syntax *STB?
Description Reads out the value of the Status Byte Register. (Query only)
Query response {numeric}<newline><^END>
Equivalent key
sequence
No equivalent key is available on the front panel.
*TRG
Syntax *TRG
Description If the trigger source is set to GPIB (set to BUS with the (:TRIG:SOUR command),
triggers the 4288A as it waits for a trigger and reads out the measured data after the
measurement is completed.
The transfer format of data read out with this command conforms to the setup of the
:FORM command.
NOTE Although this command does not have “?”, query response is given.
Query response It is the same as that of the :FETC? command. For details, refer to the description of
:FETC?.
Related commands :FETC? on page 181
:TRIG:SOUR on page 196
:FORM on page 182
Equivalent key
sequence
No equivalent key is available on the front panel.
To Next Page
Loading...
