Appendix C 255
Status Reporting System
Using the Status Reporting System
C. Status Reporting System
Using the Status Reporting System
You can manage the status report system by using the following commands in any
combination:
• *CLS on page 124
• *SRE on page 127
• *STB? on page 128
• *ESE on page 124
• *ESR? on page 125
• :STAT:PRES on page 190
• :STAT:OPER:ENAB on page 189
• :STAT:OPER:COND? on page 189
• :STAT:OPER? on page 189
For sample programs that demonstrate the use of the commands listed above, refer to
“Waiting For Completion Of Measurement (detecting completion of measurement)” on
page 55 in Chapter 5 or “Detecting the occurrence of an error” on page 95 in Chapter 8.
To Next Page
Loading...
