Agilent Technologies 4288A

30 Chapter 3
Setting Up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (save/recall function)
Saving/Recalling Instrument Setup State (save/recall
function)
You can save/recall up to 10 instrument settings into/from the built-in nonvolatile memory
(EEPROM).
For information on the instrument setups you can save/recall, refer to Table D-1, “Initial
settings, settings that can be saved/recalled, settings that can be backed up,” on page 259.
Saving instrument setup state
To save the instrument setup state, use the following command.
• *SAV on page 127
Recalling saved instrument setup state
To recall the saved instrument setup state, use the following command.
• *RCL on page 126