Agilent Technologies 4288A

Appendix D 259
Initial Settings
Initial Settings, Settings that can be Saved/Recalled, Settings that can be
Backed Up
D. Initial Settings
Table D-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Setting items
Initial settings
(factory settings)
Reset
Save/
Recall
Backup
Front panel key
(:SYST:PRES)
*RST
Measurement parameter
Primary parameter CP ¬¬lm
Secondary parameter D ¬¬lm
Measurement signal
Frequency 1 kHz ¬¬lm
Level 1 V ¬¬lm
1 MHz frequency shift 0% No effect ¬´ l
Measurement range
Ranging Auto ¬¬lm
Range setup 1 nF range ¬¬lm
Measurement time mode LONG mode ¬¬lm
Averaging
ON/OFF ON ¬¬lm
Number of counts 1 ¬¬lm
Cable length 0 ¬¬ll
Trigger
Mode Int ¬¬lm
Trigger delay time 0 ¬¬lm
Continuous activation
(:INIT:CONT) ON/OFF
ON ¬ OFF ´´
OPEN
compensation
ON/OFF OFF No effect OFF lm
Compensation
data
Primary
parameter
1 kHz 0 S No effect 0 S ll
1 MHz 0 S No effect 0 S ll
Secondary
parameter
1 kHz 0 S No effect 0 S ll
1 MHz 0 S No effect 0 S ll
Parameter type
Primary G No effect G ll
Secondary B No effect B ll
SHORT
compensation
ON/OFF OFF No effect OFF lm
Compensation
data
Primary
parameter
1 kHz 0 W No effect 0 W ll
1 MHz 0 W No effect 0 W ll
Secondary
parameter
1 kHz 0 W No effect 0 W ll
1 MHz 0 W No effect 0 W ll
Parameter type
Primary R No effect R ll
Secondary X No effect X ll
LOAD
compensation
ON/OFF OFF No effect OFF lm
Compensation
data
Primary
parameter
1 kHz 100 nF No effect 100 nF ll
1 MHz 100 pF No effect 100 pF ll
Secondary
parameter
1 kHz 0 No effect 0 ll
1 MHz 0 No effect 0 ll
LOAD
standard
definition
Primary
parameter
1 kHz 100 nF No effect 100 nF ll
1 MHz 100 pF No effect 100 pF ll
Secondary
parameter
1 kHz 0 No effect 0 ll
1 MHz 0 No effect 0 ll
Parameter type
Primary CP No effect CP ll
Secondary D No effect D ll
Offset
compensation
ON/OFF OFF No effect OFF lm
Compensation
data
Primary
parameter
1 kHz 0 F No effect 0 F ll
1 MHz 0 F No effect 0 F ll
Secondary
parameter
1 kHz 0 No effect 0 ll
1 MHz 0 No effect 0 ll