Chapter 10 133
Command Reference
:CAL:CABL
10. Command Reference
:CAL:CABL
Syntax :CALibration:CABLe <numeric>
:CALibration:CABLe?
Description Sets the measurement cable length.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric}<newline><^END>
Equivalent key
sequence
[Cable]( [Blue] - [2] )
<numeric>
Description Desired cable length
Range 0 to 2
Initial value 0
Unit m (meter)
Resolution 1
To Next Page
Loading...
Need help?
General
