Agilent Technologies 4288A

Chapter 10 191
Command Reference
:SYST:BEEP
10. Command Reference
:SYST:BEEP
Syntax :SYSTem:BEEPer[:IMMediate]
Description Produces a beep sound.
If the beep sound is disabled (OFF has been specified with the :SYST:BEEP:STAT
command), no beep sound is produced even if you execute this command. (No query)
Related commands :SYST:BEEP:STAT on page 191
Equivalent key
sequence
No equivalent key is available on the front panel.
:SYST:BEEP:STAT
Syntax :SYSTem:BEEPer:STATe {ON|OFF|1|0}
:SYSTem:BEEPer:STATe?
Description Turns ON/OFF the beep output.
This command has the same function as the :CALC:COMP:BEEP command.
Parameters
Query response {1|0}<newline><^END>
Related commands :CALC:COMP:BEEP on page 135
Equivalent key
sequence
[Config]( [Blue] - [-] ) - Beep
Description
ON or 1 (initial value) Enables the beep sound.
OFF or 0 Disables the beep sound.