Agilent Technologies 4288A User Manual

Chapter 10 155
Command Reference
:CORR:CKIT:STAN3
10. Command Reference
:CORR:CKIT:STAN3
Syntax [:SENSe]:CORRection:CKIT:STANdard3 <numeric 1>,<numeric 2>
[:SENSe]:CORRection:CKIT:STANdard3?
Description Defines the values of the LOAD compensation standard for the parameters you specify by
using the :CORR:CKIT:STAN3:FORM command.
These are set as the standard values for the measurement frequency when executing the
command (set with the :SOUR:FREQ command).
When using the multi-compensation function (set to ON with the :CORR:MULT
command) with the channel-by-channel definition of the standard values enabled (set to
ON with the :CORR:MULT:CKIT:STAN3 command), the standard values for the selected
channel (selected with the :CORR:MULT:CHAN command) are set at execution of the
command.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric 1},{numeric 2}<newline><^END>
Related commands :CORR:LOAD on page 160
:CORR:CKIT:STAN3:FORM on page 156
:CORR:MULT on page 161
:CORR:MULT:CHAN on page 161
:CORR:MULT:CKIT:STAN3 on page 162
Equivalent key
sequence
[Load]( [Blue] - [6] ) - CorVal - RefEnt
<numeric 1> <numeric 2>
Description Value of the primary
parameter.
Value of the secondary
parameter.
Range -999.999 to 999.999 -99.9999E9 to 99.9999E9
Initial value 100E-9 0
Unit F (farad) Depends on the type of
parameter.

Agilent Technologies 4288A Specifications

General

Brand	Agilent Technologies
Model	4288A
Category	Measuring Instruments
Language	English