208 Appendix A
Manual Changes
Manual Changes
Manual Changes
To adapt this manual to your Agilent 4288A, refer to Table A-1 and Table A-2.
Agilent Technologies uses a two-part, ten-character serial number that is stamped on the
serial number plate (Figure A-1). The first five characters are the serial prefix and the last
five digits are the suffix.
Execute the *IDN? command on page 125 to check the firmware version.
Figure A-1 Serial Number Plate (Example)
Table A-1 Manual Changes by Serial Number
Serial Prefix or Number Make Manual Changes
Table A-2 Manual Changes by Firmware Version
Version Make Manual Changes
1.00 “Change 1” on page 209, “Change 2” on page 209
1.10 “Change 2” on page 209
To Next Page
Loading...
