Agilent Technologies 4288A User Manual

Chapter 10 197
Command Reference
10. Command Reference
GPIB Command Table
Table 10-2 lists the 4288A GPIB commands sorted according to function
Table 10-2 GPIB Command Table
Function Item to Be Set Up/Executed GPIB command
Measurement
condition
Reset :SYST:PRES on page 193, *RST on page 126
Measurement
parameter
setup
Primary parameter :CALC1:FORM on page 147
Secondary parameter :CALC2:FORM on page 150
Measurement
signal setup
Frequency :SOUR:FREQ on page 187
1 MHz frequency shift :SYST:FSH on page 192
Level :SOUR:VOLT on page 188
Measurement
range setup
Ranging (auto/manual) :RANG:AUTO on page 185
Range :RANG on page 184
Measurement time mode setup :APER on page 130
Averaging
setup
ON/OFF :AVER on page 131
Number of counts :AVER:COUN on page 132
Cable length setup :CAL:CABL on page 133
Trigger delay setup :TRIG:DEL on page 195
Trigger mode setup :TRIG:SOUR on page 196
Compensation OPEN compensation ON/OFF :CORR:OPEN on page 165
SHORT compensation ON/OFF :CORR:SHOR on page 165
LOAD compensation ON/OFF :CORR:LOAD on page 160
Offset compensation ON/OFF :CORR:OFFS on page 163
OPEN compensation data parameter format :CORR:CKIT:STAN1:FORM on page 154
SHORT compensation data parameter format :CORR:CKIT:STAN2:FORM on page 154
LOAD
standard
definition
Value setup :CORR:CKIT:STAN3 on page 155
Definition parameter format :CORR:CKIT:STAN3:FORM on page 156
Compensation
data
Measurement :CORR:COLL on page 157
setup and read out :CORR:DATA on page 158
Offset compensation data setup :CORR:OFFS:DATA on page 164
Scanner (multi
compensation)
ON/OFF :CORR:MULT on page 161
Channel setup :CORR:MULT:CHAN on page 161
LOAD standard definition method setup :CORR:MULT:CKIT:STAN3 on page 162

Agilent Technologies 4288A Specifications

General

Brand	Agilent Technologies
Model	4288A
Category	Measuring Instruments
Language	English