Agilent Technologies 4288A User Manual

198 Chapter 10
Command Reference
Trigger Triggers a measurement :TRIG on page 195, *TRG on page 128
Trigger mode setup :TRIG:SOUR on page 196
Trigger delay time setup :TRIG:DEL on page 195
Trigger system Resets :ABOR on page 130
Initiates :INIT on page 183
Continuous activation
ON/OFF
:INIT:CONT on page 183
Measured data
output
Data transfer format setup :FORM on page 182
Data readout Measurement result :FETC? on page 181, :READ? on page 186
Data buffer :DATA? {BUF1|BUF2|BUF3} on page 168
Measurement signal monitor
result
:DATA? {IMON|VMON} on page 171
Data buffer
setup
Feeding target parameter :DATA:FEED on page 173
Control (feed/not feed) :DATA:FEED:CONT on page 174
Buffer size :DATA:POIN on page 175
Comparator ON/OFF :CALC:COMP on page 134
Limit range reset :CALC:COMP:CLE on page 136
Primary
parameter limit
range setup
ON/OFF :CALC:COMP:PRIM:BIN{1-9}:STAT on
page 143
Lower/Upper Limit value :CALC:COMP:PRIM:BIN{1-9} on page 142
Limit range designation
method (mode selection)
:CALC:COMP:MODE on page 141
Reference (nominal) value :CALC:COMP:PRIM:NOM on page 144
Secondary
parameter limit
range setup
ON/OFF :CALC:COMP:SEC:STAT on page 146
Lower/Upper Limit value :CALC:COMP:SEC:LIM on page 145
AUX BIN function ON/OFF :CALC:COMP:AUXB on page 135
Low C reject
function
ON/OFF :CREJ on page 166
Limit value setup :CREJ:LIM on page 167
BIN count
function
ON/OFF :CALC:COMP:COUN on page 137
Resets all count values :CALC:COMP:COUN:CLE on page 137
Readout of count values :CALC:COMP:COUN:DATA? on page 138
Readout of count value of
overload
:CALC:COMP:COUN:OVLD? on page 140
Readout of count values for
each channel
:CALC:COMP:COUN:MULT:DATA? on
page 139
Readout of count value of
overload for each channel
:CALC:COMP:COUN:MULT:OVLD? on
page 140
Table 10-2 GPIB Command Table
Function Item to Be Set Up/Executed GPIB command

Agilent Technologies 4288A Specifications

General

Brand	Agilent Technologies
Model	4288A
Category	Measuring Instruments
Language	English