Agilent Technologies 4288A

180 Chapter 10
Command Reference
:DISP:TEXT2:PAGE
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric}<newline><^END>
Equivalent key
sequence
[Show Setting] and [↑→ ] / [← ↓ ]
25 OPEN compensation data (primary parameter)
26 OPEN compensation data (secondary parameter)
27 SHORT compensation data (primary parameter)
28 SHORT compensation data (secondary parameter)
29 LOAD compensation data (primary parameter)
30 LOAD compensation data (secondary parameter)
31 LOAD compensation standard definition value (primary parameter)
32 LOAD compensation standard definition value (secondary parameter)
33 OFFSET compensation data (primary parameter)
34 OFFSET compensation data (secondary parameter)
Page
number
Description of displayed item
<numeric>
Description Page number
Range 1 to 34
Initial value 1
Resolution 1