NTP 161 — Replace an I-211M-K or I-211M-L indoor ONT
NTP 161-10 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Figure NTP 161-5: Power cable and power connector alignment for I-211M-K and
I-211M-L indoor ONTs
Figure NTP 161-6: Pin and pin hole configuration for I-211M-K and I-211M-L indoor ONTs
13 For an I-211M-L indoor ONT installed in an outdoor enclosure, coil the excess cable
in a clockwise direction allowing it to exit the lower right cable exit port; see
Figure NTP 161-2.
14 Verify the ONT LEDs and voltage status (DLP 127).
15 Activate and test the services (DLP 128).
16 For an I-211M-L indoor ONT installed in an enclosure, close the TELCO access cover
and secure it using a TELCO 216 screw.
17 STOP. This procedure is complete.
20554
20526
To Next Page
Loading...
