NTP 139 — Install an I-011G-P indoor ONT
NTP 139-2 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Safety information
Read the following safety information before installing the ONT.
Procedure
Use this procedure to install I-011G-P indoor ONTs.
1 Prepare the cables at the site where the ONT will be installed (DLP 100). Also,
locate the power source where the power converter will be installed.
2 Are any of the cables missing?
a If yes, go to step 3.
b If no, go to step 4.
3 Locate each missing cable and route them to the ONT as per local practices.
4 Place the I-011G-P indoor ONT:
a On the flat surface, such as a desk, horizontally resting on its four feet as
shown in Figure NTP 139-1; go to step 5.
b On a wall (DLP 122).
5 Review the connection locations shown in Figures NTP 139-1.
Danger — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when connecting or removing the cables to or from the
ONT.
Caution — Keep ONTs out of direct sunlight. Prolonged exposure to
direct sunlight can damage the unit.
Note — Observe the following:
• The ONT should be installed in accordance with the applicable
requirements of the NEC or CEC. Local authorities and practices take
precedent when there is conflict between the local standard and the
NEC or CEC.
• The ONT must be installed by qualified personnel.
• See I-011G-P detailed specifications in the unit data sheet for the
temperature ranges for this ONT.
To Next Page
Loading...
