Alcatel-Lucent 7360 - SLID Settings

6 — ONT management using an ONT interface
6-56 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Table 6-11 SLID settings
This section shows you how to:
• view or retrieve the current SLID setting
• clear (reset) the SLID
• enter or modify a SLID
Prerequisites
The prerequisites are:
• To enter a SLID, the user access level of the ONT is read-write.
• To view current SLID settings, the user access level of the ONT is read only, or
read-write.
• The ONT must have a SLID value of null or default before you can enter a new
SLID. To reset a SLID to its default value, you must clear it.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-3 for CLI interface using the craft port.
• See Procedure 6-6 for HTTP interface for Package C ONTs.
• See Procedure 6-7 for Package C ONT CLI interface using the craft port.
• See Procedure 6-8 for Package C ONT CLI interface using an Ethernet port.
Parameter Value Description
Mode Volatile In volatile mode:
• The SLID at the ONT returns to its default value
after the ONT is powered off and on.
• The SLID is delivered to the P-OLT in the
proprietary mode, which uses the proprietary
PLOAM message.
Permanent In permanent mode:
• The SLID at the ONT retains its configured value
after the ONT is powered off and on.
• The SLID is delivered to the P-OLT in the
proprietary mode, which uses the proprietary
PLOAM message.
Registration In registration mode:
• The SLID at the ONT retains its configured value
after the ONT is powered off and on.
• The SLID is delivered to the P-OLT in registration
ID mode, which uses the password PLOAM message
defined in G.984.3.
String format Hexadecimal Hexadecimal string of 0 to 9 and usually a to f or A to
F, with zeroes appended to a length of 20 characters
Alphanumeric String of up to 10 characters (default)
SLID value DEFAULT The ONT is set to a default value.
Non-default value —