6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-25
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
This section shows you how to retrieve ONT states to check the status of an ONT.
Prerequisites
The prerequisites are:
• The user access level of the ONT is read-write.
• The ONT is connected to the PON, and is ranged.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-4 for CLI interface using the first Ethernet port.
Procedures using HTTP interface
The following procedure provides the steps to check ONT status using the HTTP
interface.
Procedure 6-13 To check ONT status
1 From the Web-Management System window, click on the States Management
tab, as shown in Figure 6-9.
Figure 6-9 Main options in the Web-Management System window
The ONT status window opens with the ONT states and their current status, as
shown in Figure 6-10.
Figure 6-10 ONT status window
where
ONT state is a mnemonic that represents a possible condition on the ONT; see Table 6-7 for an
alphabetical listing and description of the ONT states
Status is the operational state of the condition, where a red button means that the condition is
present, that is active, on the ONT, and a green button means that the condition is not present,
that is inactive, on the ONT
To Next Page
Loading...
