Alcatel-Lucent 7360 - To Access the CLI Interface Using the First Ethernet Port

6 — ONT management using an ONT interface
6-14 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Procedure 6-4 To access the CLI interface using the first Ethernet
port
1 Connect a computer or laptop to the first Ethernet port on the ONT using an
Ethernet cable.
2 Configure the IP address on the laptop Ethernet port to 192.168.4.1.
3 Perform one of the following:
a If the ONT is not ranged, start a Telnet session and Telnet to 192.168.4.254.
telnet 192.168.4.254↵
b If the ONT is ranged, start a Telnet session using the IP address of the ONT.
For example:
telnet 192.168.3.10↵
4 Log in to a Telnet session:
login:login
password:password
where
login is the username for the ONT
password is the password for the ONT
The Main menu appears.
5 STOP. This procedure is complete.
Note — The 192.168.4.254 IP address remains open until the ONT has
been ranged. After the ONT has been ranged, the ONT no longer
accesses this IP address.
Note — The CLI interface requires a specific username and password.
Contact your Alcatel-Lucent technical support representative for login
and password information.