6 — ONT management using an ONT interface
6-64 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
2 Perform one of the following to enter the new SLID value in alphanumeric or
hexadecimal format in the Input New SLID field:
a In alphanumeric format, enter a numeric string of up to 10 characters.
b In hexadecimal format, enter a numeric string of up to 20 characters. The
string must be prefixed with a zero.
3 Press Apply.
4 STOP. This procedure is complete.
Procedures using CLI interface for Package C ONTs
The following procedures provide the steps to retrieve the current SLID and to
modify the SLID using the CLI interface provided with Package C ONTs.
Procedure 6-46 To retrieve the current SLID settings
1 Type S or s for Retrieve SLID from the SLID menu.
The system displays the current SLID in string format. The SLID settings are
described in Table 6-11.
2 STOP. This procedure is complete.
Procedure 6-47 To modify the SLID
1 Type M or m for Modify SLID from the SLID menu.
2 Perform one of the following to enter the new SLID value in alphanumeric or
hexadecimal format:
a In alphanumeric format, enter a numeric string of up to 10 characters.
b In hexadecimal format, enter a numeric string of up to 20 characters. The
string must be prefixed with a zero.
Note — To enter or clear a slid:
• If you are using an Ethernet connection, the ONT must be
disconnected from the PON optical cable.
• If you are using a craft connection, the ONT can be connected or
disconnected from the PON optical cable. However, if you modify
the SLID with the ONT connected to the PON optical cable, the
data at the ONT is not changed; the data at the ONT is only
changed after the ONT reranges. Rerange the ONT by
disconnecting and reconnecting the PON optical cable, which
generates a NEWONT alarm.
To Next Page
Loading...
