NTP 142 — Install an I-020E-B, I-020E-H, or I-020G-F indoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 142-3
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
iv Slide the mounting bracket over the ONT until the lip of the bracket rests
between the power connection and either the fiber optic port or the Ethernet
port. Figure NTP 142-1 shows the I-020G-F with the lip between an Ethernet
port and the power connector.
Figure NTP 142-1: I-020G-F ONT with wall mounting bracket
v Mount the ONT on the pre-installed screws or bolts in the bracket mounting
holes. Ensure the ONT is firmly held in place by the bracket and is firmly
secured to the wall.
4 Place the indoor ONT unit:
a On the flat surface, such as a desk, horizontally resting on its four plastic
feet; go to step 6.
b In the stand mount (3FE 28953 AA).
i Place the stand mount on the flat surface.
ii Slide the ONT into the opening on the stand mount, ensuring it is
securely held. Figure NTP 142-2 shows the stand mount.
19661
PON
2
Invisible laser
radiation.
Avoid direct
exposure to beam.
1
To Next Page
Loading...
