Alcatel-Lucent 7360 - Identity Data; Identity Provisioning Parameters

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-33
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Notes
(1)
This parameter can only be set on an ONT-wide basis when the parameter is configured as part of the configuration profile
(FTP download).
(2)
Does not apply to package C, D, and E ONTs and MDUs
(3)
For the I-240W-S ONT, the RegistrarRoute or RegistarRouteSec must be set the same as OutboundProxy or
OutboundProxySec.
Identity data
Table 5-11 lists the identity data. When OMCIv2 support is yes, then TL1 can be
used to configure equivalent parameters on systems supporting OMCIv2.
Table 5-11 Identity provisioning parameters
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
address_of_reco
rd
AddressOfRecor
d
Mandatory parameter that is the SIP
address of record (AOR) for the POTS
line. This is a string of up to 99
characters and is a required
parameter. The FTP XML name of
this parameter is shown as
AddressOfRecord.
When the string autofill is used, this
keyword substitutes a new address of
record, taking the form:
sip:CLIENTID +
PORT#@registrar_host,
where
CLIENTID is the TL1 and OMCI
configured value for CLIENTID
PORT# is the numeric port value,
from 1 to n, where n is the numeric
port number for the POTS line
registrar_host is the filled value of
the registrar_uri parameter.
Autofill is not supported on some
devices. Contact your support
representative for more information.
The CLIENTID and PORT# values are
concatenated, with no white space
or other delimiters between them.
YYAll Yes,
address is
constructe
d using
user part
is and host
part
parameter
s.
User part
configured in
TL1 using
USERAOR using
ed-ontvoiceport
sip
Host part
configured in
TL1 using
AORHOSTPRTPR
OFID using
ent-ontsip-confi
g
CLI using
u s e r - a o r u s i n g
configure voice
ont
voice-sip-port
aor-host-prt-pro
f or using
configure voice
ont sip-config
realm A realm identifier that corresponds
to the service provider domain in
which the POTS line is registered.
The realm identifier is used in the
authentication of the user agent.
This is a string of up to 99 characters
and is an optional parameter. The
default is to use the realm parameter
from the 401/407 authentication
challenge.
Some devices use an SS 401 response.
Contact your support representative
for more information.
YYAll
except
package
C, D,
and E
Yes,
defined in
authentic
ation
security
method.
In TL1
length is
up to 25
characters
.
Defined in
authentication
security method
REALM using TL1
using
ed-ontvoiceport
sip
CLI using realm
using
configure voice
ont
voice-sip-port
(1 of 3)