Alcatel-Lucent 7360 - HPNA Spectral Mode Specifications; SWRD Interface Specifications

3 — ONT and MDU general and interface technical specifications
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 3-21
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
• compliance with symbol timing during baud transitions in G.9954 section 7.5.4
• minimum transmission of all constellations from 2 bits-per-Baud to 8 bits-per
symbol; receives all constellations from 2 bits per symbol to 8 bits per symbol
• interface transmitter gain or phase imbalance as noted in G.9954 section 7.5.3
• compliance with timing, synchronization, and delay parameters outlined in
G.9954 section 8.9 and all sub-sections thereof
• transmitter clock frequency within 30 ppm of nominal; crystal accuracy of +/- 20
ppm.
• spectral mode specifications as described in Table 3-10.
Table 3-10 HPNA spectral mode specifications
Notes
(1)
Spectral Mode B only supported at 12-44 MHz; 2, 4, 8, 16 MBaud
(2)
compliance with spectral masks given in section 7.8.3.1 of G.9954 for each supported spectral mode
(3)
No greater than 10-3 frame error rate with a flat channel and additive white Gaussian noise at a PSD of less than –140
dBm/Hz, measured at the receiver
(4)
Meets requirements in Table 7-14 in G.9954 for the supported spectral mode(s)
(5)
Meets requirements in Table 7-15 of G.9954 for the supported spectral mode(s)
(6)
Meets requirements in Table 7-16 of G.9954 for the supported spectral mode(s)
3.9 SWRD interface specifications
The SWRD meets the following compliance and safety standards:
• UL safety (UL 60950-1)
• EU safety (IEC/EN 60950-1)
• IP rating NEMA 4 (IP 56)
• EMC emissions (U.S. and Canada) FCC part 15, class B
• EMC emissions (Europe) EN 55022 and 55024
Specification Spectral Mode A Spectral Mode B
(1)
Spectral Mode C Spectral Mode D
transmit power limit -2 to 1 dBm -2 to 1 dBm -5 to -2 dBm -2 to 1 dBm
maximum ripple 5.0 to 19.03 db 13.0 to 27.03 db 37.0 to 51.03 db 6.0 to 34.03 db
spectral mask
(2)
— — — —
frame detection peak voltage
between center and ground
(3)
1.5 dBV 1.5 dBV -0.5 dBV 1.5 dBV
frame detection with R.M.S.
voltage as low as 500uV
(3)
1518 octet frames
encoded as 2
bits/symbol and 2
Mbaud
1518 octet frames
encoded as 2
bits/symbol and 2
Mbaud
1518 octet frames
encoded as 2
bits/symbol and 2
Mbaud
1518 octet frames
encoded as 2
bits/symbol and 2
Mbaud
attenuation performance
(4)
— — — —
passband return loss
(5)
— — — —
stopband input impedance
(6)
— — — —