Alcatel-Lucent 7360 - NTP 122-3: Molex 8-Pin Connector

NTP 122 — Replace an I-010G-B, I-020G-M, or I-040G-B indoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 122-5
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure NTP 122-2: Power connector pin configuration for I-010G-B, I-020G-M, and
I-040G-B indoor ONTs
Figure NTP 122-2 shows the power connector on an I-040G-B indoor ONT. The
power connector is exactly the same and in the same location on the I-010G-B
indoor ONT.
Figure NTP 122-3: Molex 8-pin connector
9 Power up the ONT unit by using the ON/OFF power switch.
10 If necessary, reset the ONT (DLP 126).
11 If used, configure the SLID (DLP 129).
12 Verify the ONT LEDs and voltage status (DLP 127).
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the appropriate P-OLT
Operations and Maintenance Procedures Guide for more details.
LAN 4 LAN 3 LAN 2 LAN 1
POWER ON/OFF
20533
POWER
Pin 2 Pin 8
Pin 1 Pin 3 Pin 7
20179