Alcatel-Lucent 7360 - NTP 109-1: B-8102-A and B-8112-A Business ONT Connections)

NTP 109 — Install a B-8102-A or B-8112-A ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 109-3
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure NTP 109-1: B-8102-A and B-8112-A business ONT connections)
4 Route and secure the cables to the business ONT (DLP 109).
5 Connect the ground wire (DLP 147).
6 Connect the Ethernet cables (DLP 102).
7 Connect the DS1/E1 cables to the RJ-48C ports (DLP 104).
8 Connect the POTS cables (DLP 103).
9 Connect the coaxial cable (DLP 116).
(Optional)
Class 1 power and
fiber conduit box
TELCO ACCESS
PWR
CRAFT
LINE
1
BTRY
FAIL
VIDEO
DATA
NTWK
MGMT
INTF
POTS
LINE
2
LINE
3
LINE
4
LINE
5
LINE
6
LINE
7
LINE
8
BLK
TRTRTRTR TRTRTRTR
1
2
3
4
T
R
5
6
7
INPUT RATING: DC
45V 55V 1.0A
THIS DEVICE IS INTEDED TO BE
ATTACHED TO A RECEIVER THAT IS
NOT USED TO RECEIVE OVER-THE0AIR
BROADCAST SIGNALS. CONNECTION OF
THIS DEVICE IN ANY OTHER FASHION
MAY CAUSE HARMFUL INTERFERENCE
TO RADIO COMMUNICATION AND IS
IN VIOLATION OF THE FCC RULES,
PART 15.
VIDEO
TELCO ACCESS
SF EQPT
DS1
DS2
1
SF EQPT
2
1
MODE LINK
ETHERNET
Craft port
Power and alarm
connector
Ethernet port
(RJ-45)
DS1/E1 port 1
(RJ-48C)
DS1/E1 port 2
(RJ-48C)
GND
POTS ports
(RJ-11)
Fiber storage
tray
SC/APC fiber
connector
POTS screw
type block
F-type
coaxial
18885
Warning 1 — When installing the B-8102-A or B-8112-A business ONT
according to inter-building wiring practices, a minimum 26 AWG
telecommunication line cord must be installed as the POTS cable for
those POTS ports configured as TNV-3 ports.
Warning 2 — For TNV-3 POTS ports, Primary Protector (listed to
UL497) with secondary protection that is current limiting must be
installed on all POTS wiring entering a premises.