25 — I-110G-P unit data sheet
25-10 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
ONT SoC technology consists of five key elements:
• GPON MAC
The GPON MAC element on the SoC provides the GPON interface to the TC
layer via the optical diplexer or triplexer (if using RF video). This interface
supports the FSAN standards compliant GEM mode transport and provides AES,
FEC, and data fragmentation functionality over the GPON as described in
G.984.3 (GPON TC Layer) ITU specification.
• Ethernet MAC
The SoC provides an Ethernet PHY device (either 10/100BaseT or
10/100/1000BaseT) between the GMII interface and the RJ-45 port.
• Digital Signal Processor (DSP) interface
The DSP provides voice processing and has a TDM interface to the
CODEC/SLIC devices.
• control processor
The control processor manages functions related to OMCI, IGMP, VoIP, and
Ethernet services.
• SoC bridge
The SoC bridge provides an integrated data channel between the Ethernet MAC,
the GPON MAC, the DSP, the control processor, and the other integrated
elements such as flash memory, SDRAM, the local bus controller, and the
DUART interface to the craft port if used.
25.10 I-110G-P standards compliance
The I-110G-P indoor ONT is compliant with the following standards:
• 802.3 support for 10/100/1000 Base-T ports
• G.983.3 support for dynamic bandwidth reporting (Piggyback DBRu: Mode 0)
• G.984.3 support for multicast using a single GEM Port-ID for all video traffic
• G.984.3 support for AES with operator enable/disable per port-ID level
• G.984.3 support for FEC in both upstream and downstream directions
• G984.4 (standard and revised) support for OMCI interface for ONT management
and provisioning
• G.984.5 Blocking Filter as an option
• laser compliant to FCC 47 CFR Part 15, Class B, and FDA 21 CFR 1040.10 and
1040.11, Class I, ONT support Class C or Class C+ optics as an option
25.11 I-110G-P special considerations
Upgrade considerations and limitations
Existing ONTs that use 7342 ISAM FTTU releases older than R04.06.xx and
R04.07.xx must be upgraded to use R04.00.10 software while assigned to a PON ID
value smaller than 64. For this purpose, if split ratios larger than 1:64 are being
deployed, you may choose to set aside the first PON ID as a staging point.
To Next Page
Loading...
