Alcatel-Lucent 7360 - SIP Protocol (Local Network Profile and Application Profile); SIP Protocol Parameters

5 — VoIP overview
5-26 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
SIP protocol (local network profile and application profile)
Table 5-10 lists the SIP protocol parameters. When OMCIv2 support is yes, then
TL1 or CLI can be used to configure equivalent parameters on systems supporting
OMCIv2.
Table 5-10 SIP protocol parameters
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
transport_pr
otocol
TransportPr
otcol
(1)
The name (UDP, TCP, TLS) of the
transport protocol and the port
number to be used for signaling. This
is an optional parameter, the default
protocol value is UDP and the default
port number is 5060. UDP is the only
allowed value for transport protocol.
(This parameter does not apply to
iConfig message transport.)
For package C and D ONTs, UDP is
used without any configuration
necessary.
YYPackage
A, B, H
only
Yes
Default is
UDP
TL1 using UDPPort
using
ent-ontsip-config
C L I u s i n g u d p - p o r t
using configure
voice ont
sip-config
registrar_uri
RegistrarURI
(1)
The mandatory uniform resource
identifier (URI) is used as the request
URI for all REGISTER requests. This is
a string of up to 99 characters and is
a required parameter. The FTP XML
name of this parameter is shown as
RegistrarURI.
Can use the form sip:domain or
sip:registrar_route
YYAll
except
package
C and D
Yes TL1 using
PROXYSERVPROFID
using
ent-ontsip-config
CLI using
proxyserv-prof
using configure
voice ont
sip-config
RegistrarRou
te
(1) (3)
Mandatory parameter that indicates
the address of the server or proxy to
which REGISTER requests are sent. It
is a numeric IP address or a fully
qualified domain name. This is a
string of up to 99 characters and is a
required parameter.
When the string dhcp is used, this
keyword substitutes the IP address or
domain name returned from DHCP
option 120 instead of the
RegistrarRoute parameter value. If
the DHCP server does not provide an
option 120 value, a 0.0.0.0 address is
substituted and a registration failure
alarm is raised for each configured
POTS line.
DHCP Option 120 is supported on
some devices as of Release 04.08.48.
Contact your support representative
for more information.
Can use the form
xxx.xxx.xxx.xxx:port, where
xxx.xxx.xxx.xxx is the IP address and
port is the port number from
transport_protocol
Y Y All Yes, but
registrar
address
and
registrar
route will
have the
same
address.
TL1 using
REGISTRARPROFID
and
REGISTRARPROFN
M using
ent-ontsip-config
CLI using
registrar-prof
using configure
voice ont
sip-config
(1 of 7)