Alcatel-Lucent 7360 - NTP 118-1: I-010 G-A Indoor ONT Mounted on a Flat Surface; NTP 118-2: Location of Wall Mount Holes on the I-010 G-A Indoor ONT

NTP 118 — Install an I-010G-A indoor ONT
NTP 118-4 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
5 Place the I-010G-A indoor ONT unit:
a On a flat surface, such as a desk, horizontally resting on its four plastic feet
(as shown in Figure NTP 118-1); go to step 6.
Figure NTP 118-1: I-010G-A indoor ONT mounted on a flat surface
b On a wall by sliding the I-010G-A indoor ONT unit over mounting screws.
i Measure and drill two holes 11 cm (4.3 in) apart in the wall where the
ONT will be mounted. The holes should be the same distance apart as
the holes molded into the back of the ONT enclosure; as shown in
Figure NTP 118-2.
Figure NTP 118-2: Location of wall mount holes on the I-010G-A indoor ONT
ii Attach the mounting screws in the wall.
iii Slide the wall mounting holes on the ONT down over the mounting
screws until the ONT is securely seated.
6 Connect the ac power cable to the power converter, and plug the power converter
into the electrical outlet; see Figure NTP 118-3.
19834
Alarm
Update
LAN
Optical
Power
Wall mount holes
19832