6 — ONT management using an ONT interface
6-62 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
4 Perform one of the following to enter the SLID value in alphanumeric or
hexadecimal format:
a In alphanumeric format, enter the SLID up to 10 ASCII characters of 0 to 9, a
to z, or A to Z.
b In hexadecimal format, enter the SLID up to 20 characters of 0 to 9, a to f,
or A to F, with zeroes appended to a length of 20 characters.
5 Choose option 4, Retrieve SLID, to verify that the SLID was entered correctly.
6 Perform one of the following to connect the ONT to the PON:
a If the ONT is disconnected from the PON, connect the PON optical cable to
the ONT.
b If the ONT is connected to the PON, disconnect, and then reconnect the PON
optical cable.
7 Perform one of the following to provision the ONT and services:
a If the ONT and services were preprovisioned at the P-OLT, the P-OLT will
automatically range and provision the ONT, after the ONT is connected to the
PON optical cable.
b If the ONT and services were not preprovisioned at the P-OLT, notify the TL1
or network manager GUI operator to provision the ONT and services at the
P-OLT using SLID.
8 STOP. This procedure is complete.
Procedures using HTTP interface for Package C ONTs
The following procedures provide the steps to view the current SLID settings and to
enter a new SLID at the ONT using the HTTP interface for Package C ONTs.
Procedure 6-44 To view current SLID settings
1 Select the SLID option from the ONT Admin section of the navigation tree in the
GPON ONT window.
The SLID window appears; see Figure 6-37.
Note — To enter or clear a SLID using an Ethernet connection, the
ONT must be disconnected from the PON optical cable.
To Next Page
Loading...
