6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-15
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Procedure 6-5 To disconnect from the CLI interface
1 Choose option 9, Logout, from the main menu.
2 Perform one of the following:
a If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
b If you are connected to the CLI interface through the first Ethernet port,
disconnect the Ethernet cable from the first Ethernet port.
3 STOP. This procedure is complete.
Procedure using HTTP interface for Package C ONTs
Package C ONTs support limited configuration using a web-based GUI. The ONT
must support an HTTP server, and the computer must have a supported HTTP client
(Web browser).
The following procedures provide the steps to access the HTTP interface.
Procedure 6-6 Login to web-based GUI
1 Open a web browser and enter the IP address of the ONT in the address bar.
The login window appears.
The default gateway IP address is http://192.168.50.101. You can also obtain the
IP address using DHCP after connecting your PC to the layer 3 UNI.
2 Enter your username and password in the Login window.
The default username is root while the default password is admin.
3 Click OK.
4 STOP. This procedure is complete.
Note — Contact your Alcatel-Lucent technical support
representative for a list of supported Web browsers.
Note — If you forget the current username and password, press the
reset button for 5 s and the default values for the username and
password will be recovered upon start up.
To Next Page
Loading...
