19 — I-010S-P and O-010S-P unit data sheet
19-4 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Receiver Specifications
Table 19-3 describes the 010S-P receiver specifications.
Table 19-3 010S-P Receiver Specifications
Line code scrambled
NRZ
Mask margin 5%
Rise and fall times 250 ps
Tx power (EOL) 0.5 dBm 5 dBm
Tx power set up (BOL) 1 dBm 4.5 dBm
Launched power with BEN disabled −4.5 dBm
ER 10 dBm
Tolerance to Tx incident light power −15 dB
Linewidth 1 nm
SMSR 30 dB
Jitter transfer NA 0.1 dB
Jitter generation from 4kHz - 10MHz NA 0.1 dB
Differential input voltage 300 mV p-p 1800 mV p-p
Input impedance, differential 100 Ω
BEN enable 16 bits
BEN time 12.86 ns
BEN disable time 12.86 ns
Burst width 100 ns
APC setting time after power up 1.7 ns
Tx disable/enable 2 V Vcc
Tx disable/disable 0 V 0.8 V
Tx fault enable 2.4 V Vcc+0.3
Tx fault disable 0.4 V 0.8 V
Tx SD high 2.4 V Vcc+0.3
Tx SD low 0.4 V 0.8 V
Parameter Minimum Typical Maximum
(2 of 2)
Parameter Minimum Typical Maximum
Nominal bit rate 2488.32
Mbit/s
Operating wavelength 1480 nm 1500 nm
BER 10e(−10)
(1 of 2)
To Next Page
Loading...
