6 — ONT management using an ONT interface
6-36 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Prerequisites
The prerequisites are:
• The user access level of the ONT is read only or read-write.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-4 for CLI interface using the first Ethernet port.
Procedures using HTTP interface
The following procedure provides the steps to check the ranging state of an ONT
using the HTTP interface.
Procedure 6-21 To check the ranging state of an ONT
1 Ensure that the ONT is connected to the GPON.
2 From the Web-Management System window, click on the States Management
tab, as shown in Figure 6-17.
Figure 6-17 Main options in the Web-Management System window
The ONT status window opens with the ONT states and their current status, as
shown in Figure 6-10.
3 Click on the Ranging tab. The Ranging State window opens with the current
ranging state, as shown in Figure 6-18.
Figure 6-18 Ranging State window
where the ranging states are described in Table 6-9
To Next Page
Loading...
