Alcatel-Lucent 7360 - Page 386

5 — VoIP overview
5-40 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
qos-dscp The differentiated services code
point (DSCP) value that should
populate the DS field of RTP packets
sent by the user agent. It is an
integer value in the range of zero (0)
to 63. The default value is the value
configured via SNMP/TL1. The TL1
default is 46.
YYPackage
A, B, H,
I-240W-
S ONT
only
Yes, XML
takes
precedenc
e over TL1
or CLI.
TL1 using DSCP
using
ent-profile-rtp
C L I u s i n g d s c p
using
configure voice
ont rtp-profile
local-ports A range of port numbers specifying
the minimum and maximum ports
numbers to be used by the user agent
for RTP media. NOTE: Only one value
is set for this parameter across all
ports in the system. This is a string.
The range is specified as a lower
bound and an upper bound,
separated by a dash. For XML, these
bounds are decimal integer values
between 0 and 65535. The default
range is 5004-6003.
Some devices handle port numbering
in increments of four, starting with
the first port for RTP and RCTP ports.
Contact your support representative
for more information.
For TL1, the range is 5000 to 65000
and the default is 50000 for the
minimum value and 60000 for the
maximum value.
YYPackage
A, B, H,
I-240W-
S ONT
only
Yes TL1 using
LOCALPORTMIN
and
LOCALPORTMAX
using
ent-profile-rtp
CLI using
local-port-min
local-port-max
using
configure voice
ont rtp-profile
enable_t38 Indicates whether T.38 support is
enabled. This is a string containing a
value of “yes” or “no.” The default
value for XML is “yes.”. The default
value for TL1 is PASSTHRU.
YYAll Yes, TL1
and CLI
default is
no but
XML
default is
yes. TL1 or
CLI takes
precedenc
e
TL1 using
FAXMODE using
ent-profile-voip
media
CLI using
fax-mode
using
configure voice
ont
voip-media-prof
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameter
(2 of 5)