Alcatel-Lucent 7360 - Page 392

5 — VoIP overview
5-46 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
service_code_ccw A set of one or more service
codes, such as *70, that the user
agent recognizes as the Cancel
Call Waiting service code. This
reflects that fact that in typical
dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may
include up to two service codes
separated by white space. The
default is “*70 1170.” In XML the
length can be up to 6 characters.
In TL1, the length can be up to 5
characters.
The same service code values
must be present in the digit map
with an ‘S’ modifier and no ‘R’
modifier.
If a configured value also
appears in the digit map with an
S modifier then they will be
processed during dialing for the
associated feature. If the value
is not in the digit map with an S
modifier, then the digits will be
treated as normally dialed digits
and not be specially processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
For other devices, the value is
“*70 1170 and cannot be
changed.
NYPackage
A, B, H
only
Yes TL1 using
CANCELWAIT
using
ent-profile-a
cccodes
CLI using
cancel-call-w
ait
using
configure
voice ont
feat-acccode
-prof
service_code_6wc A set of one or more service
codes that the user agent
recognizes as a request to
initiate a six-way conference.
This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may
include two service codes, each
up to 6 characters long,
separated by white space. The
default is “*41 1141”.
If a configured value also
appears in the digit map with an
S modifier then they will be
processed during dialing for the
associated feature. If the value
is not in the digit map with an S
modifier, then the digits will be
treated as normally dialed digits
and not be specially processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(4 of 30)