Alcatel-Lucent 7360 - Page 405

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-59
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
cfwd_implicit This value controls whether the
voice client will SUBSCRIBE to
call forwarding status NOTIFY
messages or whether the voice
client will expect to receive
NOTIFY messages without a
subscription.
If the value is set to ‘no’, the
voice client subscribes if either
of the cfwd_state or
cfwd_reminder values are set to
‘yes’.
If the value is set to ‘yes’, the
voice client will process NOTIFY
messages without having
performed a SUBSCRIBE.
The default value is ‘no’.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
session_timer_meth
od
This value controls which SIP
method is used for session timer
functionality. The options are
‘update’ or ‘invite’. The default
is ‘invite’.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
enable_warmline This value controls whether the
warm line feature is enabled.
If the value is set to ‘yes’, warm
line is enabled. When warm line
is enabled, if the
permanent_timer expires before
a caller who has picked up the
phone (gone off hook) dials any
digit, the CPE device sends an
INVITE request using the value
specified in the
direct_connect_uri property as
the requested URI.
The default is ‘no’, warm line is
disabled.
As of R4.4, the parameter is
changed to a string value. The
options are:
• True/1/Yes
• False/0/No (default)
• Subscriber
When set to Subscriber, the
subscriber can activate or
deactivate the warmline service
and configure the default
destination number for warmline
calls.
YYPackage
A, B, H
ONT
only
Yes TL1 using
DIRCONNECT
set to 0 or 1
using
ent-profile-v
oipappservic
e
CLI using
dir-conn-feat
ure
using
configure
voice ont
voip-app-serv
ice
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(17 of 30)