Alcatel-Lucent 7360 - Page 411

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-65
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
callerid_uri_prefere
nce
This parameter specifies
whether to set tel-uri as a higher
priority than sip-uri, when there
is more than one p-assert header
present.
Supported parameters are ‘sip’,
‘tel’, or ‘first’. Unsupported
values are mapped to ‘first’. If
an incoming call contains more
than one p-assert header, this
parameter controls which header
is used to populate the caller ID
data output on the phone set.
When the parameter is set to
‘sip’, the p-assert header that is
formed with a sip-uri will be
used. When the parameter is set
to ‘tel’, the p-assert header that
is formed with a tel-uri will be
used. When the parameter is set
to ‘first’ (default), it indicates
the p-assert header that occurs
earlier in the incoming INVITE
will be used for the caller ID
data. The default is ‘first’
All lines of I-240W-S ONT should
be configured the same.
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
add_media_level_cli
ne
This parameter controls the
presence of the second “c-line”,
or contact address, in the SDP for
obsolete hold. This parameter is
ignored when the obsolete_hold
parameter is not enabled. The
options are “yes” (default)
meaning the second c-line will
be added as part of the media
description, and “no”, meaning
only a single session-level c=line
is present in the SDP, and it is set
to 0.0.0.0.
All lines of I-240W-S ONT should
be configured the same.
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
direction_in_hold_r
eq
This parameter controls the
value of direction attribute
inserted into the hold SDP when
standard hold behavior is
enabled. This parameter is
ignored when the obsolete_hold
parameter is enabled. The
options are “sendonly” (default)
and “inactive”, which
correspond to the direction
attribute that is used in SDP for
the hold request.
All lines of I-240W-S ONT should
be configured the same.
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(23 of 30)