Alcatel-Lucent 7360 - Page 414

5 — VoIP overview
5-68 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
etsi_held_party_ring
back
This parameter shall control
whether or not ringing shall be
applied when a user goes on hook
with an RTP session on hold. This
parameter only applies when the
enable_esti parameter is set to
true. The default is “no”.
All lines of I-240W-S ONT should
be configured the same.
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_release_earl
iest
Specifies the code used to
release a call and return to a
two-way call by releasing the
first added call. Valid values are
in the form Rd, where d is 0-9, *,
or #. The default is an empty
string. You can only configure
the parameter when the
enable_etsi parameter is set to
true.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_release_late
st
Specifies the code used to
release a call and return to a
two-way call by releasing the
last added call. Valid values are
in the form Rd, where d is 0-9, *,
or #. The default is an empty
string. You can only configure
the parameter when the
enable_etsi parameter is set to
true.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
NYAll
except
package
C, D,
and E
No, default
value is used
in TL1.
N/A
etsi_3wc_release_ea
rliest
Specifies the code used to
reduce a three-way call to a
two-way call by releasing the
first added call. Valid values are
in the form Rd, where d is 0-9, *,
or #. The default is an empty
string. You can only configure
the parameter when the
enable_etsi parameter is set to
true.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(26 of 30)