Alcatel-Lucent 7360 - Page 455

6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-23
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
MOCA_LOSS_OF_LINK There is a loss of link on the MoCA physical
interface between the ONT and the
broadband home router.
MOCALOL
MOCA_NOT_REG There is a loss of link on the MoCA physical
interface between the ONT and the
broadband home router
MOCALOL
MSG_ERROR_MSG There is a physical layer error message from
the ONT.
MEM
OMCC_NOT_ASSIGNED The ONT fails to respond to OMCI message
requests, or loss of communication
OMCICOMM
OMCI_ENV1 State corresponds to a customer installed
device. The source of the ENV1 alarm,
which is the customer device, is at fault and
must be addressed by the customer.
ENV1
OMCI_ENV2 State corresponds to a customer installed
device. The source of the alarm, which is
the customer device, is at fault and must be
addressed by the customer.
ENV2
ON_BATTERY There is loss of external power to ONT, or
the ONT is on battery backup, or the power
supply failed.
ACFAIL (was PWR)
ONT_DEACTIVATE There is a deactivate failure of the ONT. DF
ONT_DISABLE The ONT has been autonomously disabled
because of misbehaving transmissions.
The ONTDISABLED alarm is a defense alarm
so that the ONT does not affect the entire
PON.
ONTDISABLED
ONT_RANGED The ONT is ranged. —
PHY_EQPT_ERROR_IN There is physical equipment error on ONT. PEE
PHYSICALEQUIPMENTERROR There is physical equipment error on ONT. PEE
PHYSICAL_LAYER_DISABLED Contact your Alcatel-Lucent technical
support representative for information.
—
PHYSICAL_LAYER_INACTIVE Contact your Alcatel-Lucent technical
support representative for information.
—
PON_HIGH The 1490 nm optical signal level is too high.
The ONT polls this signal level once a
second, and indicates if the alarm condition
is present.
LEVELHI
PON_LOSS The P-OLT is not receiving transmissions
from the PON.
The state normally results from a fiber
pulled from the PON interface, or the feed
into a splitter.
PONLOS
PON-LOW State indicating if the 1490 nm optical signal
level is too low
The ONT polls this signal level once a
second, and indicates whether the alarm
condition is present.
LEVELLO
ONT state Description Alarm
(2 of 3)