Alcatel-Lucent 7360 - Page 481

6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-49
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
-- ARP --
ff ff ff ff ff ff 00 e0 b1 7a 00 c0 08 06 00 01
08 00 06 04 00 01 00 e0 b1 7a 00 c0 ac 16 b5 41
00 00 00 00 00 00 ac 16 b5 4e b1 7a 00 c0 77 19
00 00 00 00 00 00 00 00 00 00 00 00
You can use a product, such as Wireshark, to decode traces.
d Choose option 4 for IGMP.
Tracing IGMP traffic allows you to monitor IGMP messages between host
devices and the ONT, and between the ONT and the LT to ensure proper IPTV
or IP video service to subscribers.
After you choose a protocol, the following trace options appear:
Trace options
===============
1. Real-time traces
2. Enable logging
3. Disable logging
Enter choice :
4 Perform one of the following:
a To view trace statements in real time:
i Choose option 1, Real-time traces. The system responds by displaying
trace statements.
Press enter key to disable real-time tracing at any
time...
ii To stop the display of trace statements, press ↵. The system responds
by displaying the Secondary menu with the message:
dbg_logger: disabling this console
b To enable logging of trace statements:
i Choose option 2, Enable logging. The following message appears:
xxxx traces logging enabled
Press enter key to continue...
where xxxx is the selected protocol
ii Press ↵ to continue. The Secondary menu appears.
iii Specify the action for the system to take when log file is full using
Procedure 6-33.
iv Disable tracing, using Procedure 6-34.
v Copy the trace log to a TFTP server, using Procedure 6-35.
5 STOP. This procedure is complete.