Viewing T1 Remote Statistics
Page 33-20
Viewing T1 Remote Statistics
To receive and monitor remote statistics on T1 ports you must enable the Facility Datalink
(FDL) protocol through the temod command. These statistics will not be available if you do
not enable FDL.
Note
Because there is no
FDL standard for E1 configura-
tions, remote statistics are not supported on E1 ports.
Viewing Total Remote Statistics
You can view remote statistics occurring during the past 24 hours on a single port by enter-
ing the following command
terts <slot>/<port>
where <slot> is the slot number where the board is located, and <port> is the port number on
the board on which you want to view statistics. For example, to view remote 24-hour statis-
tics for Port 2 on the board in slot 5, enter
terts 5/2
A screen similar to the following displays:
Remote 24-hour Period Statistics for port 2 on slot 5
Circuit Identifier : Alcatel T1 Circuit
Valid Intervals : 1 of 96 Elapsed Time : 1 of 900
ES SES BES UAS DM SEFS LES CSS PCV LOFC
====== ====== ====== ====== ====== ====== ====== ====== ====== ======
0 0000 00 0 0 0
Most of the definitions of the fields and columns in this display are the same as those used for
the telts command. See Viewing Total Local Statistics on page 33-17 for an explanation of
these statistics. The remaining statisitics are described below.
LOFC. Loss of Frame Count. A loss of frame count is the accumulation of the number of times
a “Loss of Frame” is declared.
To Next Page
Loading...
Need help?
General
