Displaying Available Diagnostic Tests
Page 36-15
Displaying Available Diagnostic Tests
The testdisp command provides the user with a display of applicable tests for a particular slot
or for the entire chassis configuration. To display available diagnostic tests for a switching
module, enter the testdisp command followed by the slot number for the module. The slot
number is an integer ranging from 1 to the number of slots in the chassis (3 for 3-slot Omni
Switch/Routers; 5 for 5-slot Omni Switch/Routers and 9 for 9-slot Omni Switch/Routers).
No default value is set and input must be provided at the time of entering the command. For
example, to display available diagnostic tests for the switching module in slot 3, enter:
testdisp 3
at the system prompt. The following is a sample display.
Ether/12 (3-0)
CSR - Tests the Command/Status Registers
VRAM - Tests the VRAM
CAMOFFBRD - Tests the CAM
BOARDUP - Basic NI Tests
CAMONBRD - Tests the CAM
VBUS - Tests the VSE/SAM
PORT - Tests the Ports
To display all available diagnostic tests for the entire chassis, excluding slot(s) occupied by an
MPX without an HRE, enter:
testdisp all
at the system prompt. The tests are displayed per slot module starting from slot module 1.
To Next Page
Loading...
Need help?
General
