Creating a New Group
Page 19-18
Creating a New Group
There are several steps involved in creating a new Group. Note that some steps apply only to
mobile groups. These steps are as follows:
1. Enter Basic Group Information, such as the Group number and type. This section starts on
page 19-19.
2. Configure the Virtual Router Port (Optional). This section starts on page 19-21.
3. Enable/disable Group Mobility and User Authentication. This section starts on page 19-27.
4. Configure Virtual Ports. This section starts on page 19-28.
5. Configure AutoTracker policies (for mobile groups only). This section starts on page 19-
34.
WAN Routing Groups follow a slightly different procedure for their creation. You will receive
prompts during the procedure asking whether you want to create one of these special
Groups.
To Next Page
Loading...
