EasyManuals Logo

Alcatel Omni Switch/Router User Manual

Alcatel Omni Switch/Router
1100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #587 background imageLoading...
Page #587 background image
Modifying a Virtual Port
Page 19-45
Modifying a Virtual Port
You can modify a virtual port through the modvp command. The modvp command is very
similar to the addvp command and the port configuration phase of the crgp command. To use
modvp, enter the command, followed by the Group number for the port, and the physical slot
and port number for the port:
modvp <Group Number for port> <Module Slot>/<Port Number>
You can specify only one port at a time. For example, if you wanted to modify the parame-
ters for Port 7 on the module in Slot 4, and the Port currently resides in Group 6, then you
would enter:
modvp 6 4/7
The procedure for using modvp is as follows:
1. Enter
modvp followed by the Group number where the port currently resides, the physi-
cal slot and port number.
2. A prompt displays requesting your confirmation:
Modify local port 7 (Virtual port (#14)) ? (y) :
Simply press <Enter> if this is the correct virtual port. The Virtual Port number in parenthe-
ses (Virtual Port #14 in this case) is the virtual port number within this entire Omni
Switch/Router. Virtual ports are numbered sequentially within the switch, not within a
Group or VLAN.
3. The virtual port configuration menu displays:
Modify Ether/8 Vport 4/7 Configuration
1) Vport : 9
2) Description :
3) Bridge Mode : Auto-Switched
31) Switch Timer : 60
4) Flood Limit : 192000
5) Output Format Type : Default (IP-Eth II, IPX-802.3)
6) Ethernet 802.2 Pass Through : Yes
7) Admin, Operational Status : Enabled, inactive
8) Mirrored Port Status : Disabled, available
9) MAC Address : 000000:000000
Command {Item=Value/?/Help/Quit/Redraw/Next/Previous/Save} (Redraw) :
Descriptions for each of the fields in this display begin on page 19-29. To change any
default value, enter the line number for the item, an equal sign (=), and then the value for
the parameter. When you have completed the configuration for this port, enter
save to
save all configured settings.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel Omni Switch/Router and is the answer not in the manual?

Alcatel Omni Switch/Router Specifications

General IconGeneral
BrandAlcatel
ModelOmni Switch/Router
CategoryNetwork Router
LanguageEnglish

Related product manuals